Api-audio The Channel Strip User Manual download pdf (Page 19)

4.3.2 Compressor Post Equalizer

When the POST EQ switch is engaged, the 527 Compressor receives the output of the 550A

Equalizer and is interfaced via the SECOND EFFECT jacks on the rear panel.

POST EQ: Moves the 527 Compressor to post the 550A Equalizer in the audio path

• 527 Compressor will interface via the SECOND EFFECT jacks on the rear panel

• 550A Equalizer will interface via the FIRST EFFECT jacks on the rear panel

• Illuminates when engaged

4.3.3 Compressor Bypass

When the COMP BYPASS switch is engaged, the 527 Compressor is completely removed from the

audio path via a hard relay-based bypass.

COMP BYPASS (Compressor Bypass): Completely removes the 527 Compressor from

the audio path

• Relay hard bypass

• Illuminates when engaged

4.3.4 Compressor Side Chain

The 527 Compressor Side Chain (detector path) is accessible via a balanced ¼” input on the rear

panel.

When the compressor type is set to NEW, the 527 Compressor Side Chain is fed by a split of the

input to the compressor. The detection path signal can be replaced by an external source by

inserting a plug in the COMPRESSOR SIDE CHAIN IN jack on the rear panel.

COMPRESSOR SIDE CHAIN IN: Replaces the signal to compressor detector

path with the inserted signal

• Only effective when compressor is set to NEW type

• Balanced, low-impedance +4dBu line level input

• Switching ¼” TRS jack

4.4 DC Link

The 527 Compressor in The Channel Strip can be linked with 527 Compressors in other units for stereo

and multichannel applications. When connected together and the LINK switches are engaged, the DC

control voltages from all units are summed together. This results in the same control changes being

applied to all compressors. While this is not a “Master/Slave” configuration, the Threshold,

Attack/Release Times, and Ratio of all units should be set to the same value to prevent one channel

from generating a disproportionate contribution to the summed control voltage.

DC LINK: Control voltage input/output jack for the 527 Compressor

• Active only when LINK switch is engaged

All DC LINK cables are ¼” TRS phone plugs wired tip-to-tip, ring-to-ring, and sleeve-

to-sleeve

• Stereo

: Cable with a ¼” TRS on each end

• Multichannel

: Cable with multiple ¼” TRS plugs

LINK: Activates the DC control voltage summing with other units

• Illuminates when engaged

1 2 ... 14 15 16 17 18 19 20 21 22 23 24 ... 33 34

No comments

Api-audio The Channel Strip User Manual Page 19